Product Carousel Tabs
Raspberry Pi Camera
Raspberry PI Infrared IR Night Vision Surveillance Camera Module 500W Webcam
This camera can also work at night.
Resolution: 5MP
Interface Type: CSI(Camera Serial Interface)
Supported Video Formats: 1080p @ 30fps, 720p @ 60fps and 640x480p 60/90 video
Fully Compatible with Raspberry Pi 3 Model B.
Plug-n-Play camera for Raspberry Pi 3 Model B.
SKU: 101009
Drone Transmitter and Receiver
Flysky FS-i6X 2.4GHz 6CH AFHDS 2A RC Transmitter With FS-iA10B 2.4GHz 10CH Receiver
Drone Transmitter and Receiver
Flysky FS-i6X 2.4GHz 6CH AFHDS 2A RC Transmitter With FS-iA10B 2.4GHz 10CH Receiver
Transmitter: FS-i6X (6 Channels)
Receiver: FS-iA10B (10 Channels)
RF Range: 2.408-2.475 GHz.
RF Power : < 20 dBm.
RF Channel: 135.
Bandwidth: 500 KHz.
Total Weight: 392 gm.
Power: 6V DC 1.5A.
SKU: 201013
Flight Controllers
Mini OSD for Pixhawk Flight Controller
ATmega328P with Arduino bootloader
MAX7456 monochrome on-screen display
FTDI cable compatible pinout
Standard 6 pin ISP header
2 independent power sections with an LED indicator on each
Solder jumpers for combining the power sections
SKU: 201122
Trending products
See All Trending productsTemperature and Humidity Sensor
LM35D Analog Temperature Sensor Module + Cable
Based on the semiconductor LM35 temperature sensor
Can be used to detect ambient air temperature
Calibrated directly in °Celsius (Centigrade)
Linear + 10 mV/°C Scale Factor
0.5°C Ensure accuracy (at +25°C)
Low power consumption, less than 60uA
Low output impedance, 1mA current through only 0.1Ω
With screw holes for easy installation and fixed. Aperture 2.6mm
SKU: 600702
Relay Switch
5V 2 Channel Relay Module
The module using Songle relay control.
AC voltage 250V, AC current 10A, maximum DC voltage 30V DC current maximum 10A.
Power indicator (green), Two ways of relay status indicator light (red).
Using 8550 transistor-driven, strong driving ability.
Has the fixed bolt hole and easy installation.
SKU: 601514
Interface Module
DB9 Female Screw Terminal to RS232 RS485 Conversion Board
Brings all 9 pins of a DB9 connector to screw terminal blocks
Adapter used for communication debug
9 pcs signal line was all lead out, name and number clearly labeled;
All-copper DR9 seat, anti-oxidation, better contact;
Military board, three anti-paint sprays an entire board, corrosion-resistant;
Terminal spacing 3.96MM, screw hole diameter 2MM, need to use a width of 2MM screwdriver for assembly;
Use of environmentally friendly copper terminals, through IS0-9001.
SKU: 601804
Wi-Fi Module
DOIT Mini Ultra-Small size ESP-M3 Serial WiFi Module Compatible with ESP8266
Derived from ESP8266, ESP8285 has a flash memory of 1MB
Operating Voltage: 3.3V
Totally compatible with ESP8266
WiFi support 802.11 b/g/n/e/i
High temperature resistant, working temperature: -40°C-125°C
SKU: 602101
XBEE ZIGBEE Module
XBee USB Adapter FT232RL for Arduino with Cable
Microprocessor: FT232RL.
Power supply: 3.3V and 5V DC.
Interface: Mini-B USB, 2.54mm pitch pin header.
Adapter socket: XBee compatible 2.0mm pitch female pin header.
3.3V and 5V IO compatible.
USB 2.0 protocol.
Easily connected to a PC via mini USB cable.
XBee compatible 2.0mm pitch female pin header.
SKU: 602301
DC Motor Driver
L293D Motor Driver Module
The driver two holes of 3 mm dia.
Male burg-stick connectors for supply, ground and input connection.
Screw terminal connectors for easy motor connection.
High noise immunity inputs.
Operating Voltage(VDC): 4.5 to 12
Peak Current (A): 600 mA
No. of Channels: 1
SKU: 800710