Stepper Motor Driver
ULN2003 Driver Module Stepper Motor Driver Board
- ULN2003A motor driver chip
- Chip all the pins already leads for easy connection to use
- 5-12V power supply
- 4-way signal indicator
- Step angle: 5.625 x 1 / 64
- Reduction ratio: 1 / 64
- Phase: 4
- Current / Phase: 5V
₹79.00 (inc. GST)
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
-
Servo Motor Driver
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
SKU: 800504 -
Stepper Motor Driver
MACH3 Interface Board CNC 5 Axis with Optocoupler for Stepper Motor Driver and USB cable
Stepper Motor DriverMACH3 Interface Board CNC 5 Axis with Optocoupler for Stepper Motor Driver and USB cable
- Compatible with MACH3, Linux CNC (EMC2) etc. parallel-control CNC software.
- USB power supply and peripherals power phase are separate to protect computer security.
- All the signals are to-isolate which can protect your computer security.
- 5-input interface to define the Limit, Emergence-Stop, Cutter alignment, etc.
- Wide input voltage range: 12-24V, and with anti-reverse function.
- One relay output control interface, accessed by the spindle motor or the air pump, water pump, etc.
SKU: 800603 -
Stepper Motor Driver
TB6560 Driver Board 3A CNC Router Single 1 Axis Controller Stepper Motor
- Driver Chip: TB6560AHQ
- Operating Voltage: 10-35V
- Nominal Voltage: 24V
- With the large heat sink to ensure good heat dissipation
- 6N137 high-speed OptoCoupler, to ensure a high speed without step out.
SKU: 800607
There are no reviews yet.