Gas Sensor
Showing all 10 results
-
Gas Sensor
MQ 135 Air Quality/Gas Detector Sensor Module For Arduino
- Sensitivity to Ammonia, Sulphide and Benzene steam
- Sensitive for benzene, alcohol, smoke
- Fast response and recovery
- Adjustable sensitivity
- Signal output indicator
- Output voltage boosts along with the concentration of the measured gases increases.
SKU: 600106 -
Gas Sensor
MQ-2 Smoke LPG Butane Hydrogen Gas Sensor Detector Module
- Operating Voltage is +5V
- Can be used to Measure or detect LPG, Alcohol, Propane, Hydrogen, CO and even methane
- Can be used as a Digital or analog sensor
- The Sensitivity of Digital pin can be varied using the potentiometer
- Long life and low cost
- Simple drive circuit
SKU: 600102 -
Gas Sensor
MQ-3 Alcohol Detector Gas Sensor Module
- Power requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off).
- Current Consumption: 150mA.
- DO output: 0.1 and 5V.
- AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
- Detecting Concentration: 0.05-10mg/L Alcohol.
SKU: 600103 -
Gas Sensor
MQ-4 High Sensitivity Gas Methane (CNG) Detector Sensor Module
- Detecting range: 300~10000ppm
- Signal output indicator.
- Dual Signal output (analog output and TTL output).
- The TTL output signal is low level, allows us to connect with SCM directly.
- Analog output 0~5V voltage.
- Quick response and recovery.
SKU: 600105 -
Gas Sensor
MQ-6 Liquefied Petroleum Isobutane Propane Gas Sensor module
- Operating Voltage: 5V DC
- Indication of the signal output
- Dual signal output (analog output, and TTL level output)
- 0 ~ 5V analog output voltage, the higher the concentration, the higher the voltage
- High sensitivity to hydrogen
- Can be resistant to ethanol steam, LPG (petroleum), smoke interference
- Has a long life and reliable stability
- Fast response and recovery characteristics
SKU: 600101 -
Gas Sensor
MQ-7 CO Carbon Monoxide Coal Gas Sensor Module
- Operating voltage: DC 5 V.
- The analog output voltage, the higher the concentration the higher the voltage.
- The carbon monoxide detection with better sensitivity.
- With a long service life and reliable stability.
- Rapid response and recovery characteristics.
- Range: 10 to 1000 ppm.
SKU: 600104 -
Gas Sensor
MQ-8 Hydrogen Gas Sensor Module H2 Alarm Detection
- Using high-quality dual-panel design, with power indicator and TTL signal output instructions.
- The switching signal having a DO (TTL) output and analog output AO.
- TTL output valid signal is low.
- The higher the voltage, the concentration of the analog output voltage is higher.
- A hydrogen gas detection with good sensitivity.
- Has a long life and reliable stability
SKU: 600109 -